Add WLC in WCS

[armin.kraus]

Hi,

i can?t add a WLC in my WCS. The WCS can ping the controller, SNMP is configured properly. I got the message "Failed to add device to WCS". The WLC is running Version 4.0.155.0, the WCS is running version 4.0.66.0. Are there any other credentials than snmp which have to be configured ?? Have anybody these versions installed ? Thanks for any suggests.

[Scott Fella]

Did you change the default snmp strings in the controller? Make sure that the status is enabled and try setting the ip address and subnet mask to 0.0.0.0. Then try using both the read or the read/write strings. I had that issue today and I just deleted and recreated the strings.

[armin.kraus]

Thanks for reply. It works fine. Yesterday I tried this for many hours and now after deleting all strings and recreat it works. Thanks a lot.