Administering the AP (350 & 1200)

[alahmadi]

My scenario as follows:

Cisco Aironet AP (non IOS-350 series & IOS-1200 series)

ACS 3.2 appliance

Active Directory

How can I authenticate the administrators for booth non-IOS & IOS AP by the ACS 3.2?

Does non-IOS 350 series support RADIUS authentication? Or it should be upgraded to IOS?

What are the requirements to upgrade the non-IOS 350 series to be IOS?

Can I use the GUI for booth series using “https” not “http”?

Regards,

[bpotschien]

Hi,

you can access the IOS 350 with http or https. The config is simpler than the non-IOS software, I think.

When you use IOS to authenticate with ACS below is a short overview:

- create the access points as clients

Do the following in the IOS:

aaa new-model

aaa authentication login default tacacs local

tacacs-server host 1.1.1.1

tacacs-server key ANYKEY

line vty ...

login authen default

[alahmadi]

thanks for your reply

but how can i enable "https" for GUI interface??

and how to upgrade non-IOS 350 to IOS-350??

Regards,