05-07-2013 12:13 AM - edited 07-04-2021 12:02 AM
Hello,
i have this cisco aironet 1300 series.. i would like to console it.. but i cannot get to the console..i think i have a problem with its baud rate,
it will not accept the 9600.. anyone who has tried this?
thanks
05-07-2013 12:24 AM
You can use the power injector's console port for entering CLI commands to manually configure controller information. Follow these steps to connect to the power injector's console port:
Step 1 Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial console port on the power injector and to the COM port on a computer.
Note The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to http://www.cisco.com/go/marketplace to order a serial cable.
Step 2 Set up a terminal emulator, such as Windows Hyper Terminal, to communicate with the access point. Use the following settings: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
Step 3 The access point default (out-of-the-box) username, password, and enable password are all Cisco (case sensitive).
Note You must remove the serial cable from the console port when your configuration is complete.
05-07-2013 12:31 AM
i tried it many times already but i cannot go to the user interface mode..
05-07-2013 04:36 AM
What do you mean user interface? Are you able to get into the console and issue commands?
Sent from Cisco Technical Support iPhone App
05-07-2013 06:28 PM
i am not able to get into the console and issue command
05-07-2013 08:41 PM
Can you add additional info? Do you have this set properly
9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control
Sent from Cisco Technical Support iPhone App
05-07-2013 08:55 PM
yes i have set it properly as what you have stated.. this model has no mode to press to make it to the factory setting.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide