Air-CAP 1602E

[giuseppetristano1]

Hello all,

I followed the cisco procedure to go from lightweight to autonomous AP. I configured HTTP access with ip http server.

I cannot log in into the AP GUI cause the AP keeps on saying AP is not in Flex connect mode (and keeps on looking via DHCP for a WLC).

How can I stop such a behavior and login into the GUI?

Thank you in advance.

giuseppe

[Philip D'Ath]

If it mentions "Flex connect mode" then it is not in autonomous mode.

[giuseppetristano1]

Hello Philip,

Thank you for your answer. How to configure it in autonomous mode then?

giuseppe