09-04-2018 01:59 AM - edited 07-05-2021 09:05 AM
Hello.
I did update of the access-point AIR-CAP 3602I-R-K9 with ap3g2-k9w8-tar.153-3.JF8.tar
After what AP was blinking with green and no any wireless network is available.
Tried to go into CLI but seems like it is totally reseted.
I did
capwap ap controller ip address X.X.X.X
and the address has PING but no web interface.
If anybody had similar issues, please help ASAP
Solved! Go to Solution.
09-04-2018 04:09 AM
Hi,
You need to contatc to your supplier for autonomous AP software.
You can convert CAPWAP to Autonomous vai console access of AP.
How to convert:
https://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/
https://www.youtube.com/watch?v=c70mOOpqMsg
Regards
Dont forget to rate helpful posts
09-04-2018 02:34 AM - edited 09-04-2018 02:35 AM
You cant access CAPWAP over GUI. It can be reachable from SSH/Telnet of its alredy connecte dto WLC.
Is AP joined to WLC ?
Regards
Dont forget to rate helpful posts
09-04-2018 02:41 AM
Hello Sandeep,
CAPWAP is reachable for me via telnet.
Seems like I've downloaded and installed a wrong firmware for lightweight AP but I needed an Autonomous one.
Now I am not able to download it from Cisco official.
Is there possibility to revert to my old firmware?
09-04-2018 04:09 AM
Hi,
You need to contatc to your supplier for autonomous AP software.
You can convert CAPWAP to Autonomous vai console access of AP.
How to convert:
https://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/
https://www.youtube.com/watch?v=c70mOOpqMsg
Regards
Dont forget to rate helpful posts
09-04-2018 05:55 AM
Thanks a lot.
Find out the same solution and fixed it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide