AIR-CAP 3602I-R-K9 web interface

[it@bvaswa.am]

Hello.

I did update of the access-point AIR-CAP 3602I-R-K9 with ap3g2-k9w8-tar.153-3.JF8.tar

After what AP was blinking with green and no any wireless network is available.

Tried to go into CLI but seems like it is totally reseted.

I did

capwap ap controller ip address X.X.X.X

and the address has PING but no web interface.

If anybody had similar issues, please help ASAP

[Sandeep Choudhary]

You cant access CAPWAP over GUI. It can be reachable from SSH/Telnet of its alredy connecte dto WLC.

Is AP joined to WLC ?

Regards

Dont forget to rate helpful posts

[it@bvaswa.am]

Hello Sandeep,

CAPWAP is reachable for me via telnet.

Seems like I've downloaded and installed a wrong firmware for lightweight AP but I needed an Autonomous one.

Now I am not able to download it from Cisco official.

Is there possibility to revert to my old firmware?

[Sandeep Choudhary · Accepted solution]

Hi,

You need to contatc to your supplier for autonomous AP software.

You can convert CAPWAP to Autonomous vai console access of AP.

How to convert:

https://community.cisco.com/t5/wireless-mobility-documents/lwapp-to-autonomous-conversion-and-vice-versa-on-access-points/ta-p/3121542

https://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

https://www.speaknetworks.com/converting-cisco-wireless-access-point-lightweight-mode-autonomous-mode-vice-versa/

https://www.youtube.com/watch?v=c70mOOpqMsg

Regards

Dont forget to rate helpful posts

[it@bvaswa.am]

Thanks a lot.

Find out the same solution and fixed it.