04-30-2020 01:48 PM - edited 07-05-2021 12:00 PM
Hello,
We are trying to adjust the channel width on the 5GHZ radio for our 1602i Autonomous AP's
Currently using the 20mhz channel width on 5GHZ however when we try to change it on the Web GUI it just gives us an error 404 page not found on any browser/computer we use. Attached is our config (Removed SSID and some other info that shouldn't matter)
04-30-2020 05:07 PM
Simply access AP via CLI and you can make that change easily & save config (copy run start or we mem)
AAP1(config-if)#channel width ?
20 20 Mhz width
40-above 40 Mhz width with extension channel above
40-below 40 Mhz width with extension channel below
HTH
Rasika
*** Pls rate all useful responses ***
05-01-2020 09:40 AM
05-01-2020 09:50 PM
first you have to go to enable mode & then to config mode
ap>enable
ap#config t
ap#int d1
ap#channel width
HTH
Rasika
05-04-2020 04:13 PM
Here is the commands i've ran and it seems to work, however trying to reboot the AP in the GUI doesn't seem to work. Just want to make sure the configuration is being saved properly. What is the command to reboot?
enable
config t
int d1
channel width 40-below
end
copy running-config startup-config
05-04-2020 04:49 PM
simply issue "reload" command
Rasika
05-05-2020 08:17 AM
If we want the radio to run at 40mhz do we specify the 40-below or the 40-above option?
05-05-2020 02:39 PM
Either would work. Only used that with 5GHz band (radio 1)
HTH
Rasika
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide