08-10-2021 06:01 AM
I have a Cisco 1560 series Aironet Dual-Band Omnidirectional Antenna that is in lightweight mode and need to change it to autonomous mode. I was going to use the command capwap ap autonomous, but this is an invalid command. I've attached a copy of the running config, included is the capwap ap options.
Solved! Go to Solution.
08-10-2021 12:15 PM
I highly doubt you will find autonomous image for 1562, these wave 2 AP’s are designed for mobility express. So you better run mobility express on these. You need to reimage the AP by downloading mobility express software. You can find a third party guide below which I can confirm working in wave 2 ME capable APs
https://semfionetworks.com/blog/convert-a-cisco-capwap-ap-to-a-mobility-express-ap/
08-10-2021 09:49 AM
- For starters the topic autonomous versus lightweight only applies to access points, not antennas.
M.
08-10-2021 12:15 PM
I highly doubt you will find autonomous image for 1562, these wave 2 AP’s are designed for mobility express. So you better run mobility express on these. You need to reimage the AP by downloading mobility express software. You can find a third party guide below which I can confirm working in wave 2 ME capable APs
https://semfionetworks.com/blog/convert-a-cisco-capwap-ap-to-a-mobility-express-ap/
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide