Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All!I'm still learning Cisco Call Manager and my company just acquired a new office building and I need to add 20+ new phones and extensions. I've created the device pool, but I was wondering if there's a way to add the new phones along with ex...
I have a Cisco 1560 series Aironet Dual-Band Omnidirectional Antenna that is in lightweight mode and need to change it to autonomous mode. I was going to use the command capwap ap autonomous, but this is an invalid command. I've attached a copy of th...
I've installed the NIM module, but I'm not sure how to configure it. Is the NIM supposed to be configured as a separate device? If so how do I do that? If I run a sh int b, I can see the interface ports. Please let me know what information I can prov...
All four of the SFP ports should allow for trunking. Are you getting any error messages? Did you check to make sure the ports aren't disabled? Is this for fiber or copper? If fiber then the SFP's need to be the same otherwise you won't get any signal...
Is anyone having this issue with a newer version? We currently run 12.5 and when I downloaded the plugin it appeared that it would work, but after entering the username and password it would just freeze at loading.
