05-13-2011 05:22 AM - edited 07-03-2021 08:11 PM
I have a simple scnerio
PC --- AP --- Modem
When I ping from PC to AP i can do it easily , but when I ping from PC to Modem or internet it says Destination host unreachable
PC IP 10.2.2.222
AP ip 10.2.2.241
Modem IP 10.2.2.1 ( Routed Mode Connecting to Internet )
Attached is config . Is there any problem with my config , I also configured it with GUI ( web ) . It looks simple and easy but things are not working .
Please help
Solved! Go to Solution.
05-13-2011 10:17 AM
oops sorry!! guess i over read.. ok! the config looks good, however the since we are using just one SSID, no need to configure sub interfaces.. still it should work.. please remove the sub interfaces and see if that helps..
from the ap r v able to ping 10.2.2.1 or the DG??
regards
surendra
05-13-2011 05:49 AM
Ping 4.2.2.2 from the AP and see if you get any reply.. also try pinging 4.2.2.2 from the Modem and see if we are able to ping and get the replies succefully..
Regards
Surendra
05-13-2011 07:23 AM
I tried ping 10.2.2.1 ( default gateway for AP ) and no reply . I tried ping 4.2.2.2 , no reply . All Line protocols are UP . modem is working fine , it has 4mb internet connection
05-13-2011 10:00 AM
Its Simple.. if the Modem cannot go out to the internet, then the devices behind the same cannot go out!! check with the Modem vendor and ask him to NAT the interface to the routable public IP, this may help!!
Lemme know if this helps!!
Regards
Surendra
05-13-2011 10:10 AM
I think this confused you . I was saying that modem is working fine , i can access internet and everything but when I put Access Point and then ping internet or the modem from the Access point there is no reply . I have also tried changing cables ( ethernet ) and also the line protocol is up of Fastethernet0 .
Is there any problem with the Config. ?
05-13-2011 10:17 AM
oops sorry!! guess i over read.. ok! the config looks good, however the since we are using just one SSID, no need to configure sub interfaces.. still it should work.. please remove the sub interfaces and see if that helps..
from the ap r v able to ping 10.2.2.1 or the DG??
regards
surendra
05-13-2011 10:30 AM
i cant ping 10.2.2.1/ Default gateway from AP . I will remove the sub interfaces tomorrow in office . Also is there a possiblity that the AP is not working propoerly when it comes to hardware ??
EDITED
05-13-2011 10:14 PM
I removed the sub interfaces of radio and still no progress . At the moment I am using POE adapter to power up the device . Maybe its a problem with the POE device , now I will check it using power adater and ethernet cable individually
Update:
I was using POE adapter to power up that AP . I removed that and used a 3560G POE Switch to power the AP and connected through it . Things started working .
Moral of the story - It was a problem with that POE adapter .
05-14-2011 07:27 AM
Thats great to hear!! thanks for sharing the ifo!! U rock...
Regards
Surendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide