Allow Cisco LAP 1262N to ignore certificate commands

[Clay Plaga]

I have a test network that I am using for my wireless certification. I have a Cisco 5508 WLC and a Cisco LAP 1262N access point. The certificate on the access point has expired.  The software version of the WLC is  7.0.252.0. When I run this command on the CLI of the 5508 WLC:

config ap lifetime-check {mic|ssc} enable

I get an incorrect usage error. 

Update!! I fixed it. I am new to this. I was not using the command correctly. I used the command correctly, now access point has joined 5508 WLC.

Thank you.

[Rich R]

For anybody else reading this thread - read https://www.cisco.com/c/en/us/support/docs/field-notices/639/fn63942.html through very carefully and then follow all the steps, in the right order, to resolve this.