04-28-2015 08:14 AM - edited 07-05-2021 03:04 AM
When I setup my two 8510 WLC's, I think I may have not allowed static IP's for clients. How can I see on the CLI or GUI if that setting is enabled or disabled? I can't find this anywhere.
04-28-2015 08:23 AM
Under you WLAN configuration, in the advanced tab...
Look and see if DHCP Required is checked.
HTH,
Steve
04-28-2015 09:53 AM
04-28-2015 09:59 AM
DHCP is a per WLAN configuration.
When you go through the wizard setup you are configuring the first WLAN, which I usually deleted and reconfigure after the WLC is fully up after the wizard.
When you go and look at a client with a static IP on the WLC, what is the Policy State that it is in?
09-14-2017 12:40 PM
I have issue also, I stay in DHCP_REQ for policy state
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide