AP-1231G boot problem :(

[kjedroska]

I have Cisco AP-1231G.

My problem is that this AP doesnt want boot "automatically". This is console:

Xmodem file system is available.

flashfs[0]: 143 files, 7 directories

flashfs[0]: 143 files, 7 directories

flashfs[0]: Total bytes: 7741440

flashfs[0]: Bytes used: 4922880

flashfs[0]: Bytes available: 2818560

flashfs[0]: flashfs fsck took 20 seconds.

Reading cookie from flash parameter block...done.

Base ethernet MAC Address: 00:13:7f:7d:34:07

Initializing ethernet port 0...

Reset ethernet port 0...

Reset done!

ethernet link up, 100 mbs, full-duplex

Ethernet port 0 initialized: link is up

The system is not configured to boot automatically. The

following command will finish loading the operating system

software:

boot

C1200 Boot Loader (C1200-BOOT-M) Version 12.2(8)JA, EARLY DEPLOYMENT RELEASE SOF

TWARE (fc1)

TAC Support: http://www.cisco.com/tac

Compiled Wed 12-Feb-03 15:23 by hqluong

ap:

What I have to do ?

[will.shaw]

Check your Conf reg is set to 0xF

[mikeelyamys]

I have the same problem with a 1242AG, which is managed by a 4400 controller. It boots fine after I type "boot" into the console. Not sure how to set "Conf reg" to the indicated value, either through the console or the 4400.

What I can't seem to find is the equivalent to what you suggest above, nor a "Config ap boot" type of command. Any help would be greatly appreciated.