AP Setup

[avilt]

I have procured AP 1852E-EK9, just one AP which I need to setup for local use with WPA.

I have defined MGMT IP, DHCP pool etc and now I can access the AP using the browser but it's not advertising the SSID.

How can I fix it?

[avilt]

Please check the GUI output and advise. I will do a factory reset and try again.

[jagan.chowdam · Accepted solution]

There is no AP entry in your GUI screenshot. I think it's better to reconfigure ME from beginning. You can refer one of the following video tutorials for any help while setting up the ME.

https://www.youtube.com/watch?v=1zMyH2Drpno

https://www.youtube.com/watch?v=poUc5nh4_ms

Like I said before, make sure you meet the prerequisites before you start the setup.

Please rate if this is helpful

Jagan