Username:
IOS Bootloader - Starting system.
Xmodem file system is available.
flashfs[0]: 12 files, 3 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 31868928
flashfs[0]: Bytes used: 8128512
flashfs[0]: Bytes available: 23740416
flashfs[0]: flashfs fsck took 16 seconds.
Reading cookie from flash parameter block...done.
Base Ethernet MAC address: c4:7d:4f:39:3f:fe
Loading "flash:/c1250-k9w8-mx.124-21a.JA/c1250-k9w8-mx.124-21a.JA"...############################################################################################################################################################################################
File "flash:/c1250-k9w8-mx.124-21a.JA/c1250-k9w8-mx.124-21a.JA" uncompressed and installed, entry point: 0x3000
executing...
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, C1250 Software (C1250-K9W8-M), Version 12.4(21a)JA, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Mon 08-Jun-09 16:49 by prod_rel_team
Proceeding with system init
Proceeding to unmask interrupts
Initializing flashfs...
flashfs[1]: 12 files, 3 directories
flashfs[1]: 0 orphaned files, 0 orphaned directories
flashfs[1]: Total bytes: 31868928
flashfs[1]: Bytes used: 8128512
flashfs[1]: Bytes available: 23740416
flashfs[1]: flashfs fsck took 4 seconds.
flashfs[1]: Initialization complete....done Initializing flashfs.
Warning: the compile-time code checksum does not appear to be present.
Radio0 present A600 8000 A8020000 0 A8030000 30
Radio1 present A600 8000 B8020000 0 B8030000 13
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco AIR-AP1252AG-A-K9 (PowerPC 8349) processor (revision C0) with 49142K/16384K bytes of memory.
Processor board ID FTX1347912G
PowerPC 8349 CPU at 533Mhz, revision number 0x0031
Last reset from power-on
LWAPP image version 6.0.182.0
1 Gigabit Ethernet interface
2 802.11 Radio(s)
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: C4:7D:4F:39:3F:FE
Part Number : 73-10425-06
PCA Assembly Number : 800-27630-06
PCA Revision Number : B0
PCB Serial Number : FOC13450K2E
Top Assembly Part Number : 800-29039-03
Top Assembly Serial Number : FTX1347912G
Top Revision Number : A0
Product/Model Number : AIR-AP1252AG-A-K9
% Please define a domain-name first.
Press RETURN to get started!
*Mar 1 00:00:06.243: %SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS: IOS crypto FIPS self test passed
*Mar 1 00:00:07.071: %SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS: RADIO crypto FIPS self test passed on interface Dot11Radio 0
*Mar 1 00:00:07.567: %SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS: RADIO crypto FIPS self test passed on interface Dot11Radio 1
*Mar 1 00:00:07.591: %LWAPP-3-CLIENTEVENTLOG: Read and initialized AP event log (contains, 12 messages)
*Mar 1 00:00:08.539: %LINK-3-UPDOWN: Interface GigabitEthernet0, changed state to up
*Mar 1 00:00:09.527: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C1250 Software (C1250-K9W8-M), Version 12.4(21a)JA, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Mon 08-Jun-09 16:49 by prod_rel_team
*Mar 1 00:00:09.527: %SNMP-5-COLDSTART: SNMP agent on host APc47d.4f39.3ffe is undergoing a cold start
*Jan 20 18:19:18.035: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Jan 20 18:19:18.195: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to up
*Jan 20 18:19:18.195: %LINK-3-UPDOWN: Interface Dot11Radio0, changed state to up
*Jan 20 18:19:18.195: %LINK-3-UPDOWN: Interface Dot11Radio1, changed state to up
*Jan 20 18:19:18.199: %SSH-5-ENABLED: SSH 2.0 has been enabled
*Jan 20 18:19:18.503: %LINK-5-CHANGED: Interface Dot11Radio1, changed state to reset
*Jan 20 18:19:18.503: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Jan 20 18:19:19.879: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down
*Jan 20 18:19:19.879: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to down
*Jan 20 18:19:26.911: %DHCP-6-ADDRESS_ASSIGN: Interface GigabitEthernet0 assigned DHCP address 10.1.50.169, mask 255.255.254.0, hostname APc47d.4f39.3ffe
*Jan 20 18:19:36.855: Logging LWAPP message to 255.255.255.255.
*Jan 20 18:19:39.551: %CDP_PD-4-POWER_OK: 16.8 W power - NEGOTIATED inline power source
*Jan 20 18:19:39.567: %LINK-3-UPDOWN: Interface Dot11Radio1, changed state to up
*Jan 20 18:19:39.583: %LINK-3-UPDOWN: Interface Dot11Radio0, changed state to up
*Jan 20 18:19:40.555: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to up
*Jan 20 18:19:40.555: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 255.255.255.255 started - CLI initiated
*Jan 20 18:19:40.567: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
Translating "CISCO-CAPWAP-CONTROLLER"...domain server (192.168.10.207) (192.168.10.204)
Translating "CISCO-LWAPP-CONTROLLER"...domain server (192.168.10.207) (192.168.10.204)
*Jan 20 18:19:47.075: %CAPWAP-3-ERRORLOG: Did not get log server settings from DHCP.
*Jan 20 18:19:47.075: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER
*Jan 20 18:19:47.075: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-LWAPP-CONTROLLER
*Jan 20 18:19:59.091: %CAPWAP-3-ERRORLOG: Go join a capwap controller
*Aug 9 15:44:11.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 10.1.50.21 peer_port: 5246
*Aug 9 15:44:11.999: %CAPWAP-5-CHANGED: CAPWAP changed state to
*Aug 9 15:44:12.639: %CAPWAP-5-DTLSREQSUCC: DTLS connection created sucessfully peer_ip: 10.1.50.21 peer_port: 5246
*Aug 9 15:44:12.639: %CAPWAP-5-SENDJOIN: sending Join Request to 10.1.50.21
*Aug 9 15:44:12.639: %CAPWAP-5-CHANGED: CAPWAP changed state to JOIN
*Aug 9 15:44:12.743: %CAPWAP-5-CHANGED: CAPWAP changed state to CFG
*Aug 9 15:44:12.743: %CAPWAP-3-ERRORLOG: Starting config timer
*Aug 9 15:44:12.843: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Aug 9 15:44:12.847: %CAPWAP-5-CHANGED: CAPWAP changed state to UP
*Aug 9 15:44:12.851: %LINK-3-UPDOWN: Interface Dot11Radio0, changed state to up
*Aug 9 15:44:12.855: %CAPWAP-3-ERRORLOG: CAPWAP moved to Run stopping config timer
*Aug 9 15:44:12.855: %CAPWAP-5-JOINEDCONTROLLER: AP has joined controller hornell-wlc2
*Aug 9 15:44:12.899: %LWAPP-3-CLIENTEVENTLOG: SSID HB_Corporate_Internal added to the slot[0]
*Aug 9 15:44:12.899: %LINK-5-CHANGED: Interface Dot11Radio1, changed state to reset
