AP1121G, cannot access after convert to autonomous mode

[cjrchoi11]

successfully downloaded IOS via tftp server to convert the LWAPP to autonomous mode but I cannot access the AP.

I set my station to 10.0.0.5 and continous pinging to 10.0.0.1 but never response by AP. no luck even power cycle and reset (press mode button for 2 seconds while power cycle). I got 'Device no responding' message when I run IPSU.

Any idea?

Thanks in advance,

[andrew.prince]

Have you actually configured the AP with an IP address in the Fe0/0 or BVI interface?

[Scott Fella]

Have you tried to consol into the ap and take a look? Are you sure you successfully converted the AP?

Console in and reboot the ap and look at the logs and see what code the ap is running.