AP1131-AG CLI & GUI not synching

[smith606306]

I have a problem with an AP1131-AG access point.When I update the CLI it does not update on the GUI and vice versa. The access point is connected to a 3560 switch and there is no WLAN controller involved.

Has anyone else come across this problem?

[Leo Laohoo]

Did you save the config in CLI?

[smith606306]

Yes.

How do I tell if its for an autonomous or lightweight version?

The output of the show version command is:

Cisco IOS Software, C1130 Software (C1130-K9W7-M), Version 12.4(21a)JA1, RELEASE
SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Wed 16-Sep-09 18:36 by prod_rel_team

ROM: Bootstrap program is C1130 boot loader
BOOTLDR: C1130 Boot Loader (C1130-BOOT-M) Version 12.3(8)JEA, RELEASE SOFTWARE (
fc2)

APETHOS1131-0301-1 uptime is 5 weeks, 5 days, 23 hours, 22 minutes
System returned to ROM by power-on
System restarted at 09:16:49 BST Fri Jun 3 2011
System image file is "flash:/c1130-k9w7-mx.124-21a.JA1/c1130-k9w7-mx.124-21a.JA1
"

[Surendra BG]

Hi,

in the image

c1130-k9w7-mx.124-21a.JA1

W7 == Autonomous

W8 == LWAPP image

Now.. while using CLI, did u save the config?? or whats the access right?? is it READ ONLY or READ/WRITE

Lemme know if this naswered ur question and please dont forget to rate the usefull posts!!

Regards

Surendra

[smith606306]

I did the original config in the CLI and saved it but the GUI is showing no config.

I have full read/ write access

[Surendra BG]

Wat about GUI to CLI?

Regards

Surendra

[smith606306]

Ah! I only seem to have level 15 read only access to the GUI.

Attached is the config.

[Surendra BG · Accepted solution]

change the privelege and see if that works out!! and lemme know if that resolves the issue..

Please dont forget to rate the usefull posts!!

Regards

Surendra

[smith606306]

i am on privilege level 15 (highest) but it only gives me read only access from the GUI.

Any clues how to change this?