06-14-2004 12:03 PM - edited 07-04-2021 09:42 AM
I have an AP1210 IOS 12.2(15)JA. I had everything working in my lab. Now it's at a remote site and I receive the following log message even though I have an SSID configured under the dot11radio0 interface.
%DOT11-4-NO_SSID: Interface Dot11Radio0, no SSIDs configured, radio not started
I deleted and readded the ssid configuration and even reloaded the AP with no effect.
What am I missing here?
06-14-2004 12:24 PM
I have seen a similar message.
For me, it was a case that the SSID was not associated to a VLAN. Once it was, and appropriate security was re-applied, the readio came back up OK.
But yes, reloading may well be a helper here, as in my growing experience with these APs, sometimes a config change will not take until it is rebooted,and sometimes when they are re-loaded, they do not operate fully with the config they load.
Hope that helps
06-16-2004 01:00 PM
I found the problem. I actually had a typo under my FE subinterface for dot1q. The dot1q vlan was 11 in my config but my SSID was pointing to vlan 2. I changed the dot1q vlan to 2 under the my FE subinterface and the radio interface came online. Thx.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide