Wireless

We have enabled the Helpdesk role to view the AP location in WLSE. However, some helpdesk staff have moved our AP in the location manager to different location. We have to move the AP back to the designated location.Using WLSE 2.13, anyone has idea i...

As with most environment, we have wired and wireless access. The concern that we have is that when wired and wireless access are concurrently done, there is a security issue - the wireless side can be infected with malware and via it, it could spread...

We are looking for a good mini pci (not pcie) card that supports ccx4 (Cisco Compatible Extensions version 4 [added to improve searchability]) and has good client software. Our environment requires use of eap-tls with machine certificates, so ccx4 is...

Hello All, I need to find a solution for blocking unauthorised laptops being connected to my network. Is there a tool that I can use to find out from which jack and switch port the laptop was connected and also what method should I use to distinguish...

Greeting,My AP is at ap: mode after I get the massage "The system is unable to boot automatically because thereare no bootable files to boot". I can not figure out how how to re image, please assist.

Two problems.1.) 4 workstations on the same subnet, 2 can consistently ping and reach the web interface of the WiSM. 2 workstations cannot ping the WiSM, but can reach the web interface.2.) Second WiSM configured, but cannot ping or reach the web int...

Customer has 3 access points, all 1231's running 12.3(8)JA2. One of them is located in the main building (AP1). The 2nd (AP2) and 3rd (AP3) access points are located in building 2. AP2's antenna is outside and AP3's is inside. There is a crossover ca...

We are using AIR-PI21AG-A-K9 cards to connect to Cisco 1100 AP's in a Win 2k domain. After the card has been installed and configured, the PC experiences extreme sluggishness when booting up, to the point it completely locks up. If the radio is disab...

I have a 4400 series controller capable of 25 access points. I currently have 11 deployed and the controller is only seeing 10. Also if I have the need to reset a switch the AP is hanging from it can take days for the AP to find itself again, if it f...

Hello,We have a WCS 3.2, we configured to allow the user to connect via Web passthough and email.Is there a file saved on the WCS on Log or txt or other format where we could track all the username of the clients?Any Idea?Many thanks.Gael

Hello, I'm running WLSE 2.13 and I'm having this fault many times in many different APs:"Appeared Up: Compensated for by 11 radio(s)" I connect to the AP and there's nothing unusual. What could be happening?

My router hangs when it reaches 25 wireless connections.I cannot even telnet to it. I must have the onsite person power down reset to bring it back to operational.

Strange problem, when connected to a particular AP, I can't seem to connect to the same one via telnet, web, or even ping the device successfully even though my client is connected and associated fine. This happens on all models/versions. Once I roam...

Happy Friday...Trying to integrate WLC-4400 and WCS into an existing TACACS/RADIUS environment. The WLC now talks to the RADIUS server, which in turn is validating off the NT domain just fine (for network clients). But we also need to authenticate Ad...

Hi!Is it possible to set the 871W in another mode than AcessPoint?Because I'm trying to connect my 871W to an Orinoco WaveACCESS Remote Office Router (RoR), but no luck And I don't think the RoR is possible to set in other modes than AccessPoint.Anyo...