AP802 (C877VA-W modular AP) and multiple broadcast SSID's

[Hamish Marson]

Hi.

I now know that in order to have an ssid visible (broadcast) you need to set it as guest-mode in the dot11 config for the ssid. But how do i broadcast more than one ssid? When i try the AP disables the second and subsequent ssid and says only 1 ssid may be guest-mode...

H

Sent from Cisco Technical Support iPad App

[Stephen Rodriguez · Accepted solution]

You need to add the commands

Dot11 mbssid globally. Then under the main radio interface mbssid.

Under the SSID mbssid guest-mode

Steve

Sent from Cisco Technical Support iPhone App

[Hamish Marson]

Thanks. I will try that tonite

Sent from Cisco Technical Support iPad App

[jeffk]

When I type "dot11 messed" globally, I get:

ap(config)#dot11 mbssid
Dot11Radio0: MBSSID is not supported on this radio - multiple MAC addresses not found.
Dot11Radio1: MBSSID is not supported on this radio - multiple MAC addresses not found.

Error: None of the Radio Interfaces can currently support MBSSID.

What, now?