Apple Airplay not working on WLC 4402 wireless network........how can it solve !!

[bashundhara]

I have  a WLC 4402 wireless network ............. i want to enable Airplay service

[Dirk Woellhaf]

Hi,

did you enable any of the Multicast-Services on the controller? What does your setup look like?

regards,

    Dirk

[Scott Fella]

Also take a look at this doc

https://supportforums.cisco.com/docs/DOC-21728

Sent from Cisco Technical Support iPhone App

[wesleyterry]

To further add to Dirk/Scott,  since this is a 4402 there is the option of either Unicast mode or Multicast mode for  Multicast Delivery. The easiest method if scale isnt a problem is to just enable multicast unicast mode.   If you choose multicast multicast mode, then you will need to make sure that multicast routing works in the wired infrastructure (might work if APs and WLC are in the same vlan...)....     

[Dirk Woellhaf]

Hi,

the multicast-mode just referes to the connection/delivery between the controller <--> access-point. It doesn´t matter if the multicast is send in unicast or multicast to the ap.

Check if IGMP-Snooping is disabled, etc.

By the way: Multicast is not yet supported over an anchor-tunnel.

regards,

    Dirk

[bashundhara]

@ Drik ....... thanks   for reply i enable Multicast service....... i also enabled Multicast-routing in my Switch, where AP mangement VLAN r created .........

in vlan interface

configure......... # IP PIM DANS-MODE

also disible IGMP- Snooping .but not working .

The main problem is In in my netwrok i have airport express..... i joined airport express as friendly AP in WLC ..... so neighbourship is done......... hand-over process is doing well.... but Airplay option can not show when user goes in CISCO AP coverage area.............

[Saravanan Lakshmanan · Accepted solution]

keep Management, AP Manager, client connecting wlan mapped vlan on same L2 subnet if not already and try.

[bashundhara]

@Saravanan thanks .......................... work is done................