05-26-2011 04:45 AM - edited 07-03-2021 08:14 PM
Hi,
I've just installed a 2106 Controller at a remote site. The Controller is seen by the WCS at the main site so, connectivity is good and I'm able to login from the main site. I've configured the DHCP server which is at the Main site on the AP manager interface and the Manager interface and on the WLAN of the new controller but, APs are not getting addresses. Any ideas?
Thanks, Pat.
05-26-2011 10:35 AM
Hi,
I hope you have enable the option 43 in DHCP setting to discover the WLC automatically once the AP communicate with DHCP server.
Try to give static ip address or give reservation in the DHCP server.
05-26-2011 11:34 AM
Thanks for the response. I think I figured it out. The APs were shippid with the standalone image. I going to have to
change them over to LWAPP. Thanks.
Pat.
05-27-2011 12:09 AM
You can refer some videos available on CSC:-
https://supportforums.cisco.com/videos/2089
DHCP Option 43 on Cisco IOS DHCP Server
https://supportforums.cisco.com/videos/1423
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide