Wireless

Hi,Been fiddeling around with email notification in WCS 7.0.172.0. Is there a way to customize it so that it sends an email if an access point has been down for X minutes? I can't seem to find anyhting like that.Best regardsPhilip

                  I found the 3502 waps are plenum rated, I found the cable on the antenna are plenum rated, but are the antenna plenum rated?AIR-ANT5160NP-R?AIR-ANT2451NV-R?AIR-ANT2460NP-R?AIR-ANT25137NP-R?The installers want to be able to tell the ...

Hi, I am getting the following error message on a Cisco 2921 as a result of which has a there is 99 % CPU util. This router has the following cards installed and 4G WWAN EHWIC is running 15.1(4) M3 image. EHWIC_CELL_MSG-1-EHWIC_ERROR_EVENTS: eHWIC Er...

I setup a WLC5508 with 2 SSIDs, one for guest traffic and another for internal users.  They are in separate subnets and are routed out to the internet via 2 different isps, with the guest network going over a bonded t1 and the internal users going ou...

Hello,I am upgrading from 7.0.116.0 to 7.2.110.0 to support the 3602 APs.  Is it a different license to upgrade to 7.2.110.0 or can I directly upgrade to 7.2.110.0 without a new license?We currently have a 5508 base license.Thanks,Andrew

Is it possible to block outside P2P traffic on a guest wireless network using an ACL on the controller?  I know we can do it our firewall but the question came up so I thought I would post and see what everyone thinks.  TIA

is working on configure AP541n AP,  is able to connect to the AP wired, assign AP static IP with proper subnet mask & default gateway, when it's done, everything looks perfectly, but since I changed the management VLAN ID from 1 to 2, I can't even co...

The information on the Client Count graphs is no longer being populated. This was working before I did an upgrade to NCS a couple of months ago. Verified that the versions for NCS, MSE and the WLC are compatible. Any help would be appreciated.NCS - v...

Hello AllI have to WLC's a 4402 and 5508   in a mobilty group. they are both running 7.0.116.0. They are configured to use Web Authentication. We are having complaints that Users are having to re-authenticate when moving around the office. My theory ...

HIWe have some isssue related to AIR-AP1252AG-E-K9 we recently bought, and also converted to LAP, but it doesn´t register on the WLC, this WLC already on production with AIR-CAP3502N-A-K9 AP´s.It seem it´s al about the E (europe) code, but I already ...

I have two WLC 2504 controllers. These controllers are for two different buildings. But they share a VLAN, and network address range. How can I control the access points to the register selected only at a specific controller. Example:AP 1 -> WLC 1 AP...