03-19-2018 04:02 AM - edited 07-05-2021 08:24 AM
Hi ,
I hope that you are doing good.
i bought access point air-ap1815i-e-k9c for mobility express and i will use this access point to join wlc air-ct3504-k9.
How can i do it?
Thank you.
Best regards
03-19-2018 04:18 AM
You need to download a capwap image for your AP model on Cisco site. Convert it following this link and then join it on the WLC.
-If I helped you somehow, please, rate it as useful.-
03-19-2018 04:20 AM
03-19-2018 04:55 AM
Hi Flavio,
Thank you for your reply.
In this link, it's not montioned that we need dowload a capwap image for my AP to do this operation.
We need just execute command line ap-type capwap and after it will reboot to dowload capwap image from controller.
What do you thank please?
Thank's
03-19-2018 05:18 AM
My bad, the other way around need software download. You can just follow the guide.
Good luck!
-If I helped you somehow, please, rate it as useful.-
03-19-2018 04:58 AM
Hi Flavio,
Thank you for your reply.
In this link, it does not mentioned that we need dowload a capwap image for my AP to do this operation.
We need just execute command line ap-type capwap and after it will reboot to dowload capwap image from controller.
What do you thank please?
Thank's
03-19-2018 05:39 AM
Hi,
You just need three step to convert it:
Step 1 Login to mobility express CLI, type in username and password
Type Ciscoapshell and give the password
Step 2 Type Enable to go to privileged execution mode.
Step 3 Enter ap#ap-type capwap and confirm to switch to the CAPWAP type.
Regards
Dont forget to rate helpful posts
03-19-2018 07:03 AM
Thank you Sandeep for your answer.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide