Wireless

Hi,can I deploy 802.11n on AP 1242AG ?If so, what's command have to I entry ?Best regardLorenzo

I upgrade one of my 2 4404 controllers to 5.2.178.0I can't remove access points from the default-group AP Group. So it is now impossible to pick which WLANS (SSIDs)to broadcast with specific IP'sI didn't update my second controller. When I add an acc...

Hey gents,Can a client device such as the 7921G gather its own location? I think I remember a configuration example for location presence information on a client. But unfortunately I can't find the configuration guide anymore. Can anyone point me in ...

Has anyone taken this latest Cisco cert test?If so, can you telll me about it?What is the best way to study for it? Which books, etc?ThanksVL

Hi I am currently using 21 X WLC with N+1 Redundancy and 1X WCS with 1000++ of LAP1020. If had been observed that the antenna type and power TX had been changed with no reason. Is there any settings that may affect with AP customized Tx Power and ant...

One of our client is facing this issue;following is the description of the problem:"We have pair of aironet bridges one of them having problem. We have tried to change the power injector and antenna subsystem still the bridge shows problem turning on...

I have a 1252 that has joined our WLC 4402. I have checked the controller config and everythign looks good. I have WMM policy to allow, WPA2+AES,the radio shows that the channels are bonded, the channel width is set to 40MHz. I have a laptop that has...

a

Our environment:- 1,000 7921s on phone load 1.1.1- AP1130s with 15 WLCs on 4.2.130.0- WCS version 4.2.110.0We're experiencing a lot of 7921 issues that are resolved with a reboot of the phone. Is anyone experiencing this?Does anyone have a recommenda...

I would like to ask you if it is possible to configure in a remote AP the controller IP address by DHCP. I have gotten to assign an AP IP address and default gateway but, I think It don't know the controller IP address and the AP don't get to enjoy i...

Hi, I am using static ip for all the systems.And installed 1131 acees point in automouns mode with the switch.I don't have dhcp server,can access point itself will act as dhcp server.To lease ip addres to client's

We have a WLC4402 with FW 5.2.157.0. At the WLC site LAP1142N have no problems to join the WLC. This might be a prove to have a CAPWAP enabled image.00:1c:f6:XX:XX:XX.......................................... Joined (1131)00:1d:45:XX:XX:XX..............

WLC 4404 5.2.157WCS I have been watching the event logs and I have an AP or two that seem to be restarting alot. When they do the log on the WLC states that the reason for last restart was "power loss". I swapped the AP with another power injector an...