Blinking white light on an Aironet AP 2600 series (AIR-CAP2602I-E-K9)

[eloirivard]

Hello,

I have bought a AIR-CAP2602I-E-K9, I have plugged it with PoE and at startup it quickly blinks with a white light. However I cannot see what this means on the official documentation.

Is it bad? Is there something I can do?

[Miguel Angel Vazquez]

connect via console and see the ouput it shows you and share it here.

I hope you find the following information useful.

https://community.cisco.com/t5/wireless-mobility-knowledge-base/what-do-the-led-patterns-on-the-access-point-indicate/ta-p/3133183

https://www.cisco.com/c/en/us/support/docs/smb/wireless/CB-Wireless-Mesh/kmgmt-2934-cbw-startup-led-status-codes.pdf

[eloirivard]

Thank you but none of those links mention any white LED, and my AP is not in the "applicable devices" list of your second link.

[Sandeep Choudhary]

I don't think its a white light, looks to me as Blue!!

You can see the LED status on this link, its only for 2600 series AP:

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/2600/quick/guide/ap2600getstart.html#pgfId-37791

If you not able to use wireless then just get a console cable and share the debug logs here. 

Regards

Dont forget to rate helpful posts