04-10-2013 03:39 AM - edited 07-03-2021 11:53 PM
Hi
I m working on a solution for AppleTV, but some things are not clear to me.
Q: If i m going to do a Bonjour Gateway deployment, do i still need the vlan select feature on the wism's or is enabling multicast enough?
Details of the Q:
I m working with WISM s and WISM2;s, 1130 and 3602 ap;s. Cores are 6509-E's.
i m going to implement a Bonjour gateway (which is an Aerohive ap, no wifi enabled, its just a Bonjour gateway)
This ap is connected with a trunk port (to a 6509-E) and has the wifi client vlans on the trunk as allowed vlans. It also has an allowed vlan for AppleTV;s which will be wired devices.
The Aerohive gateway gets an ip address in every wifi subnet, so far so good.
I was thinking that if i enable multicast :
- globally on the wisms, with mcast-mcast distribution
- on the SVI's for the wifi client vlans
- on te SVI's of the vlans for cisco aps
- on the SVI for AppleTV
- SVI for wism management
- SVI for the Bonjour gateway
then do i still need vlan select? Maybe a stupid question, but i m not sure how to interpret some things in this document.
http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_tech_note09186a0080bb1d7c.shtml
Thanks in advance!
Solved! Go to Solution.
04-10-2013 07:17 AM
No you don't. I don't run that on my installs or on my home lab.
Sent from Cisco Technical Support iPhone App
04-10-2013 04:15 AM
Take a look at this guide as it explains what needs to be configured on the WLC and the network when using a bonjour gateway.
http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_tech_note09186a0080bb1d7c.shtml
Sent from Cisco Technical Support iPhone App
04-10-2013 04:47 AM
Hi,
that is the same document why i have asked this question.
I know it states what has to be configured, but i dont like to configure something that i dont quite get.
In this document, it is just not clear to me why vlan select is needed when deploying a gateway.
The gateway here has an ip address in each wifi vlan and an ip address in the Apple TV lan. I already tested that.
Mcast will be globally enabled on the wlan and already is enabled on the lan, so still wondering if i really need vlan select and its unfortunately not clear to me from the document.
Thanks!
04-10-2013 07:17 AM
No you don't. I don't run that on my installs or on my home lab.
Sent from Cisco Technical Support iPhone App
04-10-2013 07:37 AM
Hi
ok. Thanks very much!
Regards
Ton
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: