C1230 interrupt IOS loading

[tvaris]

Hi all,

I'm connected to autonomous 1230 AP via serial cable. The issue is that the firmware is wrong for that type of AP. When it has downloaded the wrong IOS, it boot immediately, so the loading process is in forever loop. How I can interrupt the IOS loading?

After that I can delete the wrong IOS and download correct one via XMODEM.

Thanks in advance,

~Teemu~

[Rob Huffman]

Hi Teemu,

Check this info from John;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dda31cb/0#selected_message

Hope this helps!

Rob