Wireless

I setup LAN-LAN bridge in my lab. with 1310(integ. antenna)iperf.exe test results maximum 13 mbit/secany idea?

I have access-point LAP-1242 and i want to upgrade it to autonomous. I am using the standard procedure by pressing the mode button and using the following software image c1250-k9w7-tar.124-10b.JA3 and renaming it to c1240-k9w7-tar.defaulteverything i...

I have 2 new 1410 wireless bridges on which I can not establish a wireless link using 3ft Andrews Parabolic antennas (33db gain) over a distance of about 17.7 miles. I am running the radios in autoinstall mode, have verified the azimuths and perform...

Hello! I have a wireless controller 4404, running 4.2.176.0 code. I have LAG enabled but currently have only 2 ports used, I am planning on connnecting the other two ports soon. Will this cause an outage? I am thinking no, but I want to see if anyone...

Hi,I have to install an a print wi-fi on my network deployed with Access-point 1248.Can I do it joining mac-address printer to my AP ?Anyone does advice me an a document about ?Best regardsLorenzo

I need to integrate 4402 Controller with Active Directory.If I have two distinguished names, can I use two OU like:OU=HQ,OU=Branch1,DC=DC1,DC=comIs it OK???shall I use spaces between the patrs?Please any useful points I should consider them?

I am trying to figure out a way to do a Guest Network without using an ACL tied to the SSID. (Customer's request) Its a layer 3 network and they suggested creating a DMZ zone off their ASA and connecting the WLC there that way its outside their netw...

Hi,Getting the following error message when I try to join a LWAP to my controllers in california. it then joins my controller in virginia and works...any help would be appreciated.Set Transport Address: no more AP manager IP addressesremain%LWAPP-3-...

What is the diference between WCS-APBASE-50and WCS-PLUS-50 ?.Thanks

Hi,I've got a WLAN that's currently being provided by several dozen autonomous 1130s. I've moved a few of them over onto the 4404 WLC and they broadcast the same network (same SSID, same LAN) and everything seems fine, however, clients refuse to con...

Hello!I am really stuck on a DNS issue we have with our Wireless Guest Access setup.Hope to keep it as short as possible..Setup with one anchor controller v5.2.178.0 centrally placed in our DC and several controllers placed on site at our offices. Th...

We just started testing WPA2 on our IOS APs & WLCs; no problems yet except for with the 1250. We have a 1250 running IOS 124-10b.JDA. Some users get authenticated and get a DHCP address no problems. A handful of users (no common thread yet in term...

Hello,We recently had a few clients being locked down with countermeasures by our WLC 4404 due to TKIP-MIC errors. After doing some reading on the benefits of AES over TKIP I switched our WLAN security settings to AES, and pushed a new wireless poli...

It's possible to configure Aironet 1300 Series to works as bridge and acces point in the same time ?What antenna do you recommand for point to multipoint configuration ?