11-29-2018 11:20 PM - edited 07-05-2021 09:31 AM
Hi,
I have 25AP base AP count license
I can join AP 4 only after remove will try again only 2 AP can join
please advice me
WLC code is 8.2.170.0
AP
1/30/2018 14:39:10.2585] Active version: 8.2.170.0
[*11/30/2018 14:39:10.2595] Backup version: 8.2.151.0
APWAP state: DTLS Setup(3).
[*11/30/2018 14:59:34.0164] CAPWAP State: DTLS Teardown
[*11/30/2018 14:59:38.7688] CAPWAP State: Discovery
[*11/30/2018 14:59:38.7703] Discovery Request sent to 192.168.1.25, discovery type STATIC_CONFIG(1)
[*11/30/2018 14:59:38.7736] Discovery Request sent to 192.168.10.10, discovery type STATIC_CONFIG(1)
[*11/30/2018 14:59:38.7752] Discovery Request sent to 192.168.1.25, discovery type STATIC_CONFIG(1)
[*11/30/2018 14:59:38.7762] Discovery Request sent to 192.168.10.10, discovery type STATIC_CONFIG(1)
[*11/30/2018 14:59:38.7772] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*11/30/2018 14:59:38.7774] Discovery Response from 192.168.10.10
[*11/30/2018 15:00:50.0001] Discovery Response from 192.168.10.10
[*11/30/2018 15:00:50.0000] CAPWAP State: DTLS Setup
11-29-2018 11:38 PM
12-05-2018 11:00 AM
I had a batch of 2802s purchased around May 2018 that would not join my controller running code 8.3.130. My fix was to manually load another lightweight AP image (ap3g3-k9w8-tar.153-3.JF.tar, it was small enough to load up). After this it would communicated without an issue, more importantly it would download the proper image form the WLC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide