C9800 radius-server timeout and retransmit default value

[CCC3]

Is there a default value for Server Timeout and retry count when adding radius server on c9800?

If I apply with those values blank, won't I move on to the next radius server?

[M02@rt37 · Accepted solution]

Hello @CCC3 

The default connection timeout is 5 seconds. If no response is received within that window, the controller retries the request. And, the defaur number of retries is 5.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/radius-dtls.html

[CCC3]

I think it's different from the value I thought.

What I said in the article is the timeout and retry count between 9800 and the rise.

[M02@rt37]

Mmmm OK @CCC3  

Server timeout = 5 seconds and retry count =3. 

[MHM Cisco World]

Use 

Show run all <<- this give you defualt timer use by wlc

MHM

[Rich R · Accepted solution]

Also refer to https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/technical-reference/c9800-best-practices.html#RADIUSServerTimeout

And take note of all the Best Practices and use the Config Analyzer to check your WLC config (link below)