10-05-2020 11:49 PM - edited 07-05-2021 12:36 PM
Hello.
Recently we migrate C8500 WLC to C9800 vWLC. I want to configure different country codes to different AP since they are located in different countries. At C8500 I configured Country Code from Prime using the Lightweight Access Points menu ( or via AP menu for single AP). Since this way is not used in C9800 how can I configure Country Code in C9800 to push the configuration to bulk AP's? Is there any configuration in Tags or in any component of Tags?
10-06-2020 12:41 AM
- Check the guide from here :
M.
10-06-2020 12:59 AM
I have configured the necessary county codes to support all the countries, but my question was about how to create a group with specific Country Code and assign AP to this group( like Lightweight Access Points group from Prime). It looks like C9800 doesn't support this configuration. The deployment support 2000 AP's that are in different countries. Due to Counties regulation, I can't assign the same country code to all AP's.
10-06-2020 01:06 AM
You can configure country code on 9800 WLC under "Configuraion -> Wireless -> Access Points -> Country" as shown below.
Individual AP level, you can change using individual AP's advanced configuration tab as shown below.
HTH
Rasika
*** Pls rate all useful responses ***
10-06-2020 01:25 AM
Hi.
To apply the same country code to many AP's I have to select them from Configuration -> Wireless -> Access Points -> All Access Points and then select the proper code from the Country menu, or there is no such configuration and I have to configure one by one?
Right now I haven't migrated AP's to the new controller since I have to find a solution to this problem.
10-06-2020 04:01 AM
10-06-2020 04:20 AM
I have already set up C9800 for two different countries. The tags have been configured and the corresponding Country Codes have been configured from CLI. Since the total number of AP's on those 2 countries is about 200, I was wondering if I can apply the country code in multiple AP's simultaneously and not one by one.
10-06-2020 08:17 AM
10-07-2020 01:00 AM
Hi Scott.
Thank you for your response. I will migrate the first AP the next days and check the config that will get from CLI. So the only way to config multiple AP with the same country code is only via CLI.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide