04-08-2011 07:34 AM - edited 07-03-2021 08:03 PM
hello Guys, i have an AP connected to a gigabit interface on my switch. all seems well configured.a show cdp neighbors command on the neighboring switch shows my AP as a neighbor with its IP address settings.A ping to the AP is not successful. trunking between the switch and AP is good with the allowed vlans configured on the switch interface and trunking configured.the allowed vlans on the switch correspond to the vlans on the AP.
what would this be ? before, it was functional but now not working.
any help on this is welcome.
Solved! Go to Solution.
04-08-2011 07:43 AM
Maybe you can post your switch and ap configuration ?
04-08-2011 08:01 AM
LOL easy cake...
Even if you spcify the vlan ID as native you need to allow that vlan with the switchport trunk allowed command, add 99 and that should do it.
04-08-2011 07:43 AM
Maybe you can post your switch and ap configuration ?
04-08-2011 07:56 AM
04-08-2011 08:01 AM
LOL easy cake...
Even if you spcify the vlan ID as native you need to allow that vlan with the switchport trunk allowed command, add 99 and that should do it.
04-09-2011 03:16 AM
thanks for the help Dmantill.
04-09-2011 07:01 AM
And thanks to Nicolas that requested the right information.
04-10-2011 11:01 PM
thanks for the help Nicolas.
problem solved due to the published config. you requested.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide