Hello, the below is protocol for C9800 wlc initial config. it configures physical port TwoGigabitEthernet0/0/2 as mgmt interface. We want to use layer2 svi as mgmt interface. but if we do so, it would not let us to access wlc via gui. do you think so? Is there a command for gui to be up? thanks
- Review the c9800configurationwith the CLI (I assume SSH access is already working for the moment) command :show techwireless, have the output analyzed by https://cway.cisco.com/tools/WirelessAnalyzer/ , please note do not use classicalshow tech-support(short version) , use the command denoted in green for Wireless Analyzer. Checkout all advisories!
You must be changing the configuration after the wizard. What does your configuration look like for your svi and http? I'm also assuming you have a trustpoint and you disabled http and re-enabled http(s) after you made your other changes?
This configures the service port, not the wireless management interface. I almost haven't used any Day0 Configuration wizard in any of the Cisco appliances for a long time, I am mostly comfortable with skipping it and configuring whatever I need either from CLI or GUI. I also believe that this wizard has lot of configuration limitations.
However, to skip the 0 day `wizard in GUI you need to configure the ap country in the WLC via CLI. To configure the AP country forst you need to shut down the 2.4 and 5Ghz globally in the WLC. Then configure the country and prepend no to the commands to unshut 2.4 and 5Ghz.