cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2827
Views
18
Helpful
2
Replies

C9800 AP CDP

Rajesh Kongath
Level 1
Level 1

Hi

Is there any way to display cdp information of APs on c9800 (17.6.3) controller in GUI? I am looking for the command output of "sh ap cdp neighbors" in the GUI. 

AirOS based WLCs had an option to view this on GUI Home> Network summary > Access point view - I am looking for similar option on catalyst based WLCs

TIA - Rajesh

1 Accepted Solution

Accepted Solutions

Arshad Safrulla
VIP Alumni
VIP Alumni

ArshadSafrulla_0-1669546858423.png

You may navigate as shown in the above screenshot

View solution in original post

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

There is a "Make a Wish" option on the 9800 GUI page. 

Alternatively, reach out to your Cisco AM/SE/PSS and ask them to create a PER in your behalf.

Good luck.

Arshad Safrulla
VIP Alumni
VIP Alumni

ArshadSafrulla_0-1669546858423.png

You may navigate as shown in the above screenshot

Review Cisco Networking for a $25 gift card