11-10-2022 01:08 AM
I have 2 x 9120axi EWC APs & i cannot get the day 0 configuration to work.
They are both running version 16.12.04a & i go through the setup procedure where prompted to input the ip address for the interface, subnet mask, default route & username/ password.
interface GigabitEthernet0
no switchport
no shutdown
ip address 10.64.170.21 255.255.255.0
!
ip route 0.0.0.0 0.0.0.0 10.64.170.1
!
username admin privilege 15 password 0 Cisco123!
In the documentation i have seen, at this point i should see an SSID being broadcasted, but there is none.
Also, i cannot ping the interface GigabitEthernet0 from the locally attached switch?
I have tried the factory reset using the button on the AP, but still cannot get any further.
Am i missing something?
thanks Colin
Solved! Go to Solution.
11-10-2022 02:36 AM
I have resolved this issue, you need to use dhcp when you boot AP out of the box.
then complete the tasks following he command "cat ewc_day0_device_provisioning_guide"
then run setup to manually configure the mgmt ip address & overide the dhcp assigned ip address
at that point you can then browse the GUI & configure.
11-10-2022 01:16 AM
I have also ran the command "cat ewc_day0_device_provisioning_guide" & followed all of the instructions listed in the displayed text output. Still no SSID being broadcast & i still cannot ping the interface. I have tried configuring the switchport as both an access port & a trunk port.
11-10-2022 02:36 AM
I have resolved this issue, you need to use dhcp when you boot AP out of the box.
then complete the tasks following he command "cat ewc_day0_device_provisioning_guide"
then run setup to manually configure the mgmt ip address & overide the dhcp assigned ip address
at that point you can then browse the GUI & configure.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide