Hi Community,
Last saturday we upgraded the IOS-XE version of our C9800-40 (x2) and the standby one is in initialization state still:
ESGSDC-WLC#sh redundan state
my state = 13 -ACTIVE
peer state = in progress to standby cold-bulk
Mode = Duplex
Unit = Primary
Unit ID = 2
Redundancy Mode (Operational) = sso
Redundancy Mode (Configured) = sso
Redundancy State = sso
Maintenance Mode = Disabled
Manual Swact = disabled (peer unit not yet in terminal standby state)
Communications = Up
client count = 146
client_notification_TMR = 30000 milliseconds
RF debug mask = 0x0
Current client in progression = BINOS_BULKSYNC_CLIENT (33010)
Time since client was sent progression (ms) = 2245569
History for this client progression = RF_PROG_STANDBY_BULK, rc 0
ESGSDC-WLC#
We do not know why it has not yet synchronized and we have not found information on the Cisco website to help us.
Could you tell us the reason why the standby has not synchronized or how we can force it? We need to configure some additional parameters and right now we can't:
ESGSDC-WLC#conf t
Config mode cannot be entered during Standby initialization or when switch is in recovery mode
Thank you in advance.
Regards.
