06-14-2021 08:08 AM - edited 07-05-2021 01:27 PM
I was trying to figure out if there is a way from the CLI on an AP (a 3702i in this case) if I could tell which controller the AP was actually associated to. I can run a "show capwap client config" to show what the config is, but I have found some cases where the AP is not necessarily connected to that controller, for example if the config has a type-o. Is there a command that will show me which controller the AP is actually taking to?
c3702-test-1#show capwap client conf configMagicMark 0xF1E2D3C4 chkSumV2 27869 chkSumV1 9192 swVer 17.3.3.26 adminState ADMIN_ENABLED(1) name c3702-test-1 location Main hallway group name WAS mwarName c9800-1-lab mwarIPAddress 10.3.2.1
Solved! Go to Solution.
06-14-2021 04:51 PM
sh capwap client rcb
06-14-2021 04:51 PM
sh capwap client rcb
06-15-2021 09:14 AM
Thank you!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: