Change Management VLAN on AP (Access Points)

[helenio]

Hi,

I'd like to move the management interface of an AP1100 to another VLAN (i.e 100). and reach it trough Ethernet port that is configured for 802.1q to carry the two VLAN abova. I tried to add Interface BVI100 but and assign it an IP but doesn't work. Have you suggestion ?

[j-block]

Check your IOS version, this is suorted from 12.2(13)JA.

[helenio]

I have the version 12.2(13)JA4, and I discovered that to move the Management VLAN I have to put the command:

interface fastethernet 0.100 (Management VLAN)

encapsulation Dot1Q vlan 100 native

bridge-group 1

exit

!!!!!

This allow me to move the Management VLAN to VLAN ID 100 the problem is that the native VLAN became the Management VLAN 100. My target is to move the management VLAN away from native VLAN and away from VLANID=1. It seam that Management VLAN an the AP can not br separate from native VLAN.

Someone may confirm that ?

[mmcsweeny]

Hi,

you will need to change the native vlan on the AP to be the new management vlan id

r.

mark