- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2019 08:01 AM - edited 07-05-2021 11:11 AM
Hello,
I have a Cisco 3702i setup in autonomous mode that has been running for a few weeks. I can SSH into it using my new username and password, but can't use this to log into the GUI I have to use the default of Cisco:Cisco, it seems to be the only one that will work on the GUI.
What do I need to do to remove the default username and password and create a new one for GUI access?
Thanks
Solved! Go to Solution.
- Labels:
-
Aironet Access Points
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2019 04:47 PM - edited 10-24-2019 02:57 PM
Hi Andrew,
IT expect enable password. So try your new username with enable password combination. That should work (by default exec & enable password both are "Cisco", hence confusing)
HTH
Rasika
**** Pls rate all useful responses ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-23-2019 04:47 PM - edited 10-24-2019 02:57 PM
Hi Andrew,
IT expect enable password. So try your new username with enable password combination. That should work (by default exec & enable password both are "Cisco", hence confusing)
HTH
Rasika
**** Pls rate all useful responses ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-24-2019 05:53 AM
Ah yes that worked, very confusing.
