02-02-2009 01:19 PM - edited 07-03-2021 05:05 PM
In particular, 1200 series AP's
I cant find a link anywhere in the setup (using the GUI interface).
Thanks for the help.
Lonny
02-02-2009 01:57 PM
Use the CLI:
clock timezone
clock summer-time
Does this help?
02-02-2009 02:09 PM
Hi Lonny,
Just to add a note to the good tips from Leo (+5 points Leo :)
From this good guide;
Hope this helps!
Rob
02-02-2009 02:29 PM
Thanks Rob, that guide only talks about using the CUI. I need to know if there's a way to configure it thru the GUI.
Not big on using the CUI as most AP's are already mounted and my understanding is you need to use the console port for CUI commands, correct?
Lonny
02-02-2009 04:06 PM
Hey Lonny,
No worries!
Q. How do I change the date and time settings on the Cisco 1231 AP?
A. Go to the web interface (GUI), choose Services > SNTP, select Time Settings and then change the time.
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a008009483e.shtml
Hope this helps!
Rob
PS: If enabled, you can also access the AP via Telnet and ssh for cli commands :)
02-02-2009 09:07 PM
The SNTP link was the one I needed. Thanks Rob...
02-02-2009 02:53 PM
Thanks Rob, that guide only talks about using the CUI. I need to know if there's a way to configure it thru the GUI.
Not big on using the CUI as most AP's are already mounted and my understanding is you need to use the console port for CUI commands, correct?
Lonny
02-02-2009 04:49 PM
If it's in Autonomous mode, you can telnet into the AP. If it's Lightweight mode, the configuration has to be done on the WLC (CLI or GUI).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide