channel verify

[yytellmey]

Hi,

How can I verify what channel the Cisco 1200 AP is using? The only way I know is "show run". Is there any other way?

Thanks,

yytellmey

[Rob Huffman · Accepted solution]

H yytellmey,

Give this a try;

Use the show controllers dot11Radio0 command in order to show the frequency and channel that the AP or bridge is on. This example output shows where to find the information:

ap#show controllers dot11Radio0

!

interface Dot11Radio0

Radio AIR-AP1242GA, Base Address 0014.1b58.08f

Version 5.80.12

Serial number: GAM09200992

Number of supported simultaneous BSSID on Dot1

Carrier Set: Americas (US )

DFS Required: No

Current Frequency: 2412 MHzChannel 1

Hope this helps!

Rob

Please remember to rate helpful posts............

[yytellmey]

Thanks Rob. It is what I need.

Thanks,

yytellmey