05-29-2013 12:54 PM - edited 07-04-2021 12:09 AM
Hi,
I am a bit confused with the GUI configuration of an AP and repeater my concerns are:
I have 3 AP 1142 series i want two APs to be connected to the main AP(ethernet) while the others act as repeaters.
How do i go about creating an AP as a repeater to assoicate with the AP connected to a switch
Thanks
Solved! Go to Solution.
05-29-2013 01:18 PM
Why go repeater mode? Why not go root/non-root bridge?
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
05-29-2013 01:18 PM
Why go repeater mode? Why not go root/non-root bridge?
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
05-29-2013 02:29 PM
Hello Samson,
As per your query i can suggest you the following solution-
Configuring a Repeater Using the CLI
If you want to configure your AP as a repeater and use the command-line interface, the following is an example configuration setting. This example configures the AP with two parents:
ap1130# configure terminal
ap1130(config)# interface dot11radio 0
ap1130(config-if)# ssid qbranch
ap1130(config-ssid)# infrastructure-ssid
ap1130(config-ssid)# exit
ap1130(config-if)# station-role repeater
ap1130(config-if)# dot11 extensions aironet
ap1130(config-if)# parent 1 0012.7fc2.1bdc 1000
ap1130(config-if)# parent 2 0012.44b4.b250 1000
ap1130(config-if)# end
ao1130# copy running-config startup-config
Hope this will help you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide