04-23-2020 12:29 PM - edited 07-05-2021 11:58 AM
HI,
I am trying to configure a Cisco 1830 AP as an ME WLC.
I am able to initially provision the AP using the provisioning SSID and apply the initial settings. However, when I reset the AP and try to connect using the configured management IP I have no ip connectivity.
The management interface on the ME is untagged as per Cisco documentation.
The connected switchport is configured as a trunk trunking the native vlan.
This has happened on two separate APs so I'm confident that it is not an AP hardware/software issue.
Wondering if anyone else has come across this issue when configuring an ME WLC AP.
I am running Cisco ME version 8.8
Thanks
Scott
04-23-2020 01:29 PM
Hello,
Indeed after you reboot the ME the management interface is untagged.
What configuration you have on the ME what on the switch? can you see L2 traffic?
04-24-2020 01:38 AM
05-31-2020 06:15 AM - edited 05-31-2020 06:49 AM
If AP1830 ME using Management Static IP.
?
1. do I still need dhcp server
2. if I don't have internal dhcp server. Could I use AP1830 act as DHCP server
3. If I have internal DHCP server. what ip subnet should I assign on that if AP1830 ME Management ip is 192.168.1.x
tq
UPDATE1: SOLVED
need to configure ME DHCP Server
06-02-2020 01:06 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide