10-09-2013 06:25 PM - edited 07-04-2021 01:03 AM
I setup my 2504 to work with OEAP. When I enabled NAT on the management interface the one AP I have directly connected to the WLC is no longer getting an IP address. Any idea why this is?
Solved! Go to Solution.
10-11-2013 06:58 AM
First, it is not recommended to have an AP directly connected to the WLC, you really need to connect it to an upstream switch and let it connect that way.
My first thought would be that you need to take a look a the below link that talk about how the NAT ip commands work.
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
10-10-2013 01:59 PM
Any help here?
Sent from Cisco Technical Support iPhone App
10-11-2013 06:58 AM
First, it is not recommended to have an AP directly connected to the WLC, you really need to connect it to an upstream switch and let it connect that way.
My first thought would be that you need to take a look a the below link that talk about how the NAT ip commands work.
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
10-11-2013 07:16 AM
Just so you know i only have one AP plugged directly in the WLC becuase there is no POE in this area and the AP sits 5feet from the WLC.
I ran the following commands which seem to fix my issues.
config ap link-latency disable all
config network ap-discovery nat-ip-only disable
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide