Wireless

Hi, I have an existing setup where in i have a 4400 WLC and AP 1242 registered to it.I had to replace the WLC with a new 5500 WLC. I tried registering the the 1242 AP with this new controller but i'm getting the following error message: AP0026.0b4d.0...

Hi folks I have been trying to figure out why my download speeds are not as fast as I expect.  I have recently installed a Cisco 2702 in place of my Cisco 1041 AP.   I have the AP plugged into a Cisco 1921 router via a non Cisco dumb 10/100/1000 swit...

We have a site that wants to "bridge in" a small building with no fiber run to it. That building is only 400-500 feet from a fully connected building, so we are suggesting they use a pair of 3502e with directional antennae mounted outside. The AP in ...

We have 2500 WLC and planning to USE ISE for AAA functions. Before we start I would like to know if 2500 has any limitations with

Hi All, The config file in my controller shows this two commands:config network broadcast enableconfig network multicast global enable Running 'show network summary' gives me this:Ethernet Multicast Forwarding............... DisableEthernet Broadcast...

Dear Community I manage a topology based upon wlc with different licensing sizes that is getting centralized. previously there were wlc in every location, the target is all on flexconnect with a pair of wlc at a central site.does anyone know how to c...

I have a new installation of a WLC 8510 running 8.0.110Now we need to deploy 300x AIR-CAP702W that has 4 ethernet ports We need special config for each of the ports - is there a way to template the install so we don't have to change each AP individua...

Hi all,I've got a licensing issue regarding my two controllers, previously noticed because APs are not joining the controller. The primary controller should be configured with a HA license (I can't see it in the output), and looks like it needs to ha...

Dear Team, Is there any free  software for wireless passive and active survey and report generating as well ? Regards

Hi, I have a scenario in which I have an Existing WLC in place. The task is to install another WLC which is going to be in HA with this WLC.The new WLC would be in a different geographical location than the Primary (Existing) WLC. As per my understan...

HiOn a WLAN , i am trying to configure local WLC as anchor controller - when i click on the Anchor controller button on the WLAN page it takes me to Anchor Controller setting - in the drop down i can see other controllers in the mobilty group but can...