03-30-2017 09:58 PM - edited 07-05-2021 06:46 AM
My network is working fine. i am also able to take GUI access of cisco 2702i standalone by directly connecting my laptop on the Switch Port and after manually configured eth port of my PC.
but i am not able to take GUI over the wireless network even if i am connecting the same subnet SSID Vlan 10-192.168.10.0/24
IP configured on Access point:- 192.168.10.10/24
i am also able to ping the POE switch vlan interface on which AP is connected. int vlan 10 192.168.10.8
please suggest what is the reason behind this.
03-31-2017 02:11 AM
try with another browser!!
Regards
Dont forget to rate helpful posts
03-31-2017 02:21 AM
On lightweight APs this is normally disabled for security reasons. Can you connect via SSH or telnet to the AP, assuming it's running in Autonomous mode?
03-31-2017 02:34 AM
yes it is running in Autonomous (standalone) mode. i also run IP HTTP server and IP HTTP secure server commands on CLI. but still GUI is not accessible over the LAN network..
03-31-2017 02:36 AM
Ok, that sounds good.
Have a look here, maybe this helps: http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15_2_4_JB/configuration/guide/scg15-2-4-Book/scg15-2-4-chap2-gui.html#64205
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide