I All,
We have few AP's to be connected newly to network and when a new one boots it goes through as mentioned in this thread of discovering and joining an AP in same network.
https://community.cisco.com/t5/other-wireless-mobility-subjects/cant-join-2602e-ap-to-2802-mobility-express-controller/m-p/3942568#M101760
how to get in to this AP which returns a cisco controller prompt?
(Cisco Controller)
User: admin
Password:********
User:admin
Password:*****
User:deafult
Password:*******
User:
Eventhough DHCP provides option 43 with WLC ip, AP never joins the WLC or downloads code.
001#sh cdp neigh gi2/0/48 detail
-------------------------
Device ID: AP3C51.0E40.E18E
Entry address(es):
IP address: 10.180.xx.140
IPv6 address: FE80::3E51:EFF:FE40:E18E (link-local)
Platform: cisco AIR-AP2802I-Z-K9, Capabilities: Router Trans-Bridge
Interface: GigabitEthernet2/0/48, Port ID (outgoing port): GigabitEthernet0
Holdtime : 152 sec
Version :
Cisco AP Software, ap3g3-k9w8 Version: 8.8.125.0
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2014-2015 by Cisco Systems, Inc.
advertisement version: 2
Power drawn: 26.000 Watts
Power request id: 58341, Power management id: 3
Power request levels are:26000 15400 0 0 0
Management address(es):
IP address: 10.180.xx.140
How to convert this to a LWAP mode AP.
