02-11-2019 06:00 PM - edited 07-05-2021 09:50 AM
Hi,
Does anyone tested the Cisco 3504 WLC HA SSO? I've tested the setup in a standalone network were the two WLC is connected to a switch and HA is working fine but when the WLC is connected to actual setup i've encountered peer communication down error between two WLC's.
WLC is connected to a separate DC. Please attached diagram for reference.
Thank you,
Arvie
02-11-2019 06:46 PM
02-11-2019 06:48 PM
When the WLCs are not directly connected there are requirements around connecting the RP port
For the redundancy port:
Requirements for L2 connection: RTT Latency: < 80 ms; Bandwidth: > 60 Mbps; MTU: 1500
If you are not meeting these requirements you will not get SSO to work
02-11-2019 10:15 PM
Hi,
Yes I am using 3504 HA AP/Clinet SSO in my Plant and its working fine.
As in other posts mentioned......You just need to take of these parameter :
RTT Latency: < 80 ms; Bandwidth: > 60 Mbps; MTU: 1500
Regards
Dont forgete to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide