07-31-2012 11:23 AM - edited 07-03-2021 10:28 PM
I have a Cisco 5508 setup at a host site with 3 other sites connected using hreap on 1252APs. When doing testing of network speed I find that the throughput from the wireless to wired network is at about 18mbps yet the same test on wired side is 85-100mbps and wireless to wireless is 18mbps
Any ideas what could cause this
07-31-2012 11:45 AM
Hi Jeff,
do you use local switching in hreap mode?
If you are tunneling traffic back to WLC WAN connection could be your limiting factor.
HTH
Sebastian
Sent from Cisco Technical Support iPad App
07-31-2012 12:45 PM
It is set to local swiching for each of the five vlans setup- a tracert shows correct path from point a to b
07-31-2012 02:59 PM
Hm, just guessing is hard. So ...
Can you upload the configuration?
Which standard do you use? .11n? Encryption method?
Where you the only one on ap while taking the tests?
Have you tried some tests at various daytimes?
Any chances to check for interference or change channels?
Sebastian
Sent from Cisco Technical Support iPad App
07-31-2012 03:06 PM
as well, what type of switchport is the AP connected to? 10/100 or 10/100/1000
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide